Print Profile(1)
0.12mm layer, 2 walls, 100% infill
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
1
8
6
0
42
14
Released
Description
HueForge Iguana created for the Polymaker Green Start Pack of Filaments. Only manual filament swaps required.
Print at 100% infill with a layer height of 0.12mm with a base layer of 0.24mm
Filaments used Polymaker Green Starter Pack:
- Polymaker PolyTerra Charcoal PLA Black Transmission Distance: 0.3
- Polymaker PolyLite Pro PLA Green Transmission Distance: 1
- Polymaker PolyLite Lime PLA Green Transmission Distance: 3.5
- Polymaker PolyLite PLA White Transmission Distance: 5
Swap Instructions:
- Start with PolyTerra Charcoal Black
- At layer #6 (0.84mm) swap to PolyLite Green
- At layer #9 (1.2mm) swap to PolyLite Lime Green
- At layer #12 (1.56mm) swap to PolyLite White for the rest.
Comment & Rating (6)
All
Great hueforge .
1
Reply
Print Profile
0.12mm layer, 2 walls, 100% infill
sehr schön
The designer has replied
1
Reply
Vielen dank
0
Reply
Print Profile
0.12mm layer, 2 walls, 100% infill
Turned out great!
1
Reply
Print Profile
0.12mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 100% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld