Chevy Bow Tie Logo - Replacement for rear badge on Chevy Volt
Copyright Claim
Chevy Bow Tie Logo - Replacement for rear badge on Chevy Volt
Boost
52
42
14
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
2 plates
Boost
52
42
14
0
161
115
Released
Description
Rear bowtie logo replacement for Chevy Volt (made logo to replace the stolen logo from my car)
Logo as seen in photo is 7 inches wide.
Comment & Rating (14)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Great print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
both prints great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good print, but not quite the right fit for an HHR if you're wondering
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
flawless
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld