This is my shower/multipurpose basket!

I made two versions, one 100mm plus hook, the other one 150mm plus hook.

You can use this basket to hang it onto the shower tap or onto a hook, as i did, to store your shower gel and hair shampoo in it. No more reaching for the shower gel and shampoo on the floor of the shower!

Also, there are many more purposes to use this basket for, e.g. in the hobby work shop, kitchen or for household items.

Print instructions:

• set the support type to “auto” and style to “snug”
• layer height 0,20mm
• 3 wall loops
• top/bottom shells 4 layers
• top/bottom shell thickness 0,80mm
• sparse infill 15%
• sparse infill pattern “gyroid”

Before printing: make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.

Before printing, make sure your build plate has a decent adhesion. Aftermarket plates like the ones from Alibaba often have no good adhesion. Curling will probably occur if you don’t use original build plates or if you don't make sure the plate is clean and oil free! Bad build plate adhesion is not related to the model or the design.

Please have a look at my other models and leave me a like if you were satisfied with the model and the print. Thank you in advance!

https://makerworld.com/en/u/1597610120