Hygrometer Mount for P1S , 0.2mm layer height 15% infill 2 wall
Copyright Claim
Hygrometer Mount for P1S , 0.2mm layer height 15% infill 2 wall
Boost
96
181
57
Print Profile(2)
0.2mm layer, 2 walls, 15% infill , no support (PETG)
Designer
15 min
1 plate
0.16mm layer, 2 walls, 15% infill
15 min
1 plate
Boost
96
181
57
1
349
286
Released
Description
fit with round hygrometer at 41mm inner diameter and 45.5mm outer diameter
inspired by seeing this model and want to make it tighter and be able to use the current screw bolt
Comment & Rating (57)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Thank you for sharing.
(Edited)
2
Reply
great to know you like it
(Edited)1
Reply
Works great.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Perfect fit. Thank you!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
best design found for this
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill , no support (PETG)
Perfect print in ABS! Thanks for sharing🤩
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill , no support (PETG)
0
Reply
Can I print without support?
The designer has replied
1
Reply
yes , you can print without support
0
Reply
Which hygrometer did you buy to fit this? Is it battery or hard wired?
The designer has replied
1
Reply
it's on battery , in Thailand we can buy from application platform "shopee" , "Lazada" and cost about usd $1
0
Reply
it’s actually hygrometer, hydrometer is something different 🙂
The designer has replied
1
Reply
my bad , just corrected , thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill , no support (PETG)
The print fit and works exactly as sold. Only issue I have is on my end probaby with lighting but it is hard to rear through the tinted glass of the door. But I also don't have the best lighting and that's not the print it's the glass door. Also it was very nice to keep the original hardware
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld