I never saw an AMS riser that checked all my needs; I just wanted to take my Build plates near my Printer and enlighten the Build area.
My goal was to hold up to 4 Build plates, and I didn't want to remove the Top glass or build a gasket or something like the other AMS riser out there. :)
This design has a relatively low Profile of 40,8mm and is designed to takes m5x16 Screws and Nuts. The Nuts are friction-fit, and you may need to push them in with a bit of force.
I also added a way to detach the power cable from the controller via 2-pin JST plugs, which I ordered from Amazon. https://www.amazon.de/gp/product/B082ZLYRRN/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1
The RGBWW LEDs are from AliExpress and are 12,5mm wide and 3mm tall.
The Feet are some felt pads that I had lying around.
I added the f3d if you want to adjust some things; it's mostly parametric.
If you have any suggestions, write them in the comments. :)