Pill Pot - Multi Segment Remixed by BobbyDazzler

Remixed by

BobbyDazzler

Tools>Medical Tools

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

1.1 h

1 plate

5.0(3)

Open in Bambu Studio

Boost

Released

Description

Evolution of my other single pill pot, this one is slightly larger and has 4 sections with a rotating cover with window so you can empty a segment without the rest of your pills falling out. It's larger than the old pot at 55mm diameter and 23mm tall (the single pot is ~40mm in diameter but the same height)

The rotating inner part is held in place with an M3x12mm bolt which screws into the base (that's the shiny dot on the base you can see) it is made to take a bolt with a head of dimensions 5mm diameter and 3mm height. You could get away without the bolt, the design works perfectly fiine without it, but you will need to hold the inner in place if you tip the pot up to empty a segment.

I plan to add a 7 segment pot as well, as soon as I get the size I'm happy with I'll add the files

Comment & Rating (4)

@user_2314003925

Print Profile

0.16mm layer, 2 walls, 15% infill

this print never stuck to the bed tryed a few times and will try again , problem could be at my end

The designer has replied

@BobbyDazzler

off the top of my head a couple of things to try: wash your bed (dish soap or alcohol) thoroughly. a thin layer of glue stick on your bed often helps with adhesion. try adding a brim in your slicer as this will give you more surface area to stick to the bed. finally make sure you’ve dried out your filament or try it with a freshly opened roll.