Pill Box /Screwtop container

DOWNLOAD THE V2 VERSIONS AS THIS HAS THICKER WALLS AND SHOULD AVOID ISSUES WITH PRINTING AROUND THE THREADED SECTION 

Big enough to hold the 1 days worth of the cocktail of drugs I need to take on a daily basis. No reason it can't be used to hold other things as long as they're smaller than a 50p. It's not watertight (tbh I haven't tested it) so don't complain if your contents get wet.

Seem to have a lot of these from using up the scrap ends of spools of filament.

According to Cura, uses 3m of filament. Be sure to flip the parts so they print with the “lid” facing the bed, that way you won't need supports.

I've remixed this model here with the following changes:

• Thicker walls around the thread on the base, should hopefully make printing more reliable for the threads.
• Slightly higher base, not sure if the volume has changed significantly, but there were was couple of mm between the top of the base and the lid that wasn't getting used.
• A pill motif on the lid so I know which way is up (difficult to tell in the original version).

And if you need a larger pot to hold 7 days worth of pills I made one of those as well

Edit:

DOWNLOAD THE V2 VERSIONS AS THIS HAS THICKER WALLS AND SHOULD AVOID ISSUES WITH PRINTING AROUND THE THREADED SECTION 

I have added models for v2 with thicker walls to improve print quality for threaded part as some have reported issues with failed prints around the threads, this should fix that issue.

I left the v1 files in just in case you still want the file.