I love Arkham Horror so I made a Cthulhu inspired picture. Hope you like it!

If you only have one AMS leave the last filament empty so that it pauses when it gets to it. Then switch all the rolls needed. This is how I do mine.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Orange Transmission Distance: 10
    PLA BambuLab Basic BambuLab Green Transmission Distance: 8
    PLA BambuLab Basic Gray Transmission Distance: 2
    PLA BambuLab Basic Beige Transmission Distance: 8
    PLA BambuLab Matte Ice Blue Transmission Distance: 3.5
    PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
    Start with Black
    At layer #12 (1.04mm) swap to Orange
    At layer #15 (1.28mm) swap to BambuLab Green
    At layer #16 (1.36mm) swap to Gray
    At layer #18 (1.52mm) swap to Beige
    At layer #19 (1.6mm) swap to Ice Blue
    At layer #20 (1.68mm) swap to Jade White for the rest.