Remote control holder 4 departments
Remote control holder 4 departments
Print Profile(2)
Description
This my remote control holder with 4 departments!
You no longer have to look for the remote control all over the living room. Store them at your table in this holder.
The print is possible without AMS! The body and side walls are on separarate plates.
After printing, simply slide in the walls. No gluing necessary!
Print instructions:
- layer height 0,20mm
- 3 wall loops
- top/bottom shells 4 layers
- top/bottom shell thickness 0,80mm
- sparse infill 10%
- sparse infill pattern “gyroid”
Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.
Before printing, make sure your build plate has a decent adhesion. Aftermarket plates like the ones from Alibaba haven’t good adhesion. Curling will probably occur if you don’t use original build plates! Bad build plate adhesion is not related to the model or the design!
If necessary, cut off a little bit of the edges as shown in this picture:
Update 06.02.2024: by user request i uploaded a version with a wider last department. The last department of the new version is 45mm deep. The new print profile is named "wider last departmet".
Comment & Rating (60)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
