This my remote control holder with 3 departments!

You no longer have to look for the remote control all over the living room. Store them at your table in this holder.

I also made a version with 4 compartments: https://makerworld.com/en/models/153970#profileId-168273

The print is possible without AMS! The body and side walls are on separarate plates.

After printing, simply slide in the walls. No gluing necessary!

If necessary, cut off a little bit of the edges as shown in this picture:

Print instructions:

• layer height 0,20mm
• 3 wall loops
• top/bottom shells 4 layers
• top/bottom shell thickness 0,80mm
• sparse infill 10%
• sparse infill pattern “gyroid”

Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.

Before printing, make sure your build plate has a decent adhesion. Aftermarket plates like the ones from Alibaba haven’t good adhesion. Curling will probably occur if you don’t use original build plates! Bad build plate adhesion is not related to the model or the design!

Please have a look at my other models: https://makerworld.com/en/u/1597610120

If you were satisfied with the model and the print, leave me a like, i would appreciate it. Thank you in advance!