Print at 100% infill with a layer height of 0.08mm with a base layer of 0.20mm
If you don't have AMS simply replace all “color change” in the sidebar with “pause” instead and all layer heights are then set.
Otherwise use the settings below.
Filaments Used:
Sunlu PLA+ Black
Azurefilm PLA Wine Red
3DE PLA Chilli Red
3DE PLA Flame Orange
Sunlu PLA+ Yellow
3DE PLA Light Grey
Swap Instructions:
Start with Black
At layer #08 (0.76mm) swap to Wine Red
At layer #11 (1.00mm) swap to Chilli Red
At layer #14 (1.24mm) swap to Flame Orange
At layer #18 (1.56mm) swap to Yellow
At layer #21 (1.80mm) swap to Light Grey for the rest.
If you scale, make sure not to change Z height.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.