Use a larger nozzle for quicker printing. Very tight print, needed a dead blow hammer to slide the boxes together.

Love it. good design.

when attaching multiple copies together the fit is VERY snug - I needed to pound them into place. on the other hand, once attached they will not easily come apart.

I printed 5 of these the last few days and overall love them. If I could give some minor feedback and criticism: 1) The side-by-side connections work like a charm, but when stacking on top I'm finding those connectors are extremely tight. I connected two on top of one another and they're so tight I can't hope to ever get them apart again. 2) I'd love a version of this with the front knob that is more discrete? Just a little smaller. For such a small drawer, it seems overall in both aesthetics and amount of filament used. (Drawer 2 that doesn't need support filament) 3) I'd also love a version for bottom, top, left, right where there are no connectors. It'd save on filament if I'm printing 3 that I know will always be bottom pieces so they don't need the connectors down there, so on and so forth for my outer left pieces, right, and top. If that makes sense! I think it'd be really sleek too when all done. 4) I'd really love a version of this that let you set some of these horizontal and vertical and connect. So instead of all of them being horizontal, put one up on it's side on let's say the right of a bunch of them, and have two smaller drawers inside stacked one on top of the other! Overall, I really like this.