Poop Slide (remix)
Remixed by
Copyright Claim
Poop Slide (remix)
Remixed by
Boost
12
10
17
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
12
10
17
1
39
28
Released
Description
Liked the attachment method of n1vy3d, but needed it to go off the side into a trash can.
Printed without support, but had one slight bridge string, but was not an issues (it is for poop after all).
Attaches using the same screws as for the poop chute - no magnets required.
Printed with PLA.
Comment & Rating (17)
All
can you make an extension tor this?
The designer has replied
0
Reply
how much longer would you need?
0
Reply
Replying to @dallasstarsfan
5 inch
0
Reply
Replying to @Regan
Uploaded Poop Slide (extended).3mf to the raw models section. Requires supports as it had to be rotated to fit on the build plate. Did not test printing it, so could not upload a profile. Hope it works out for you.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
just what I was looking for a straight shot for the poop
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great model 👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld