Update 2/5/19:

After several weeks of testing, it seems I need to increase the clip length to 200% in Cura (Uniform scaling turned OFF!) . This is because the clips randomly popped off.

• I will update this later to see if this fixes my issue

I made a clip which holds the bag in place.

• It tears the bag a little but its not a major issue

Dimensions (See attached image)

• Inside width is .6 in (15.24mm)
• Overall width of .9 in (22.89mm)
• Design has 1in depth

This should help you edit the ratio in Cura to suit your needs.

• I used 90% width in cura to fit my trash can. Uniform scaling turned off!

• I used 10% zigzag infill.

• I used 50% depth ratio ( .5in depth ) and it turned out fine

I am the owner of https://www.neocrisis.com