P1S glass riser

P1S glass riser

Boost
67
117
75

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
6.6 h
2 plates
4.9(58)

EASY 0.6mm nozzle, 0.3mm layer, 3 walls, 15% infill
EASY 0.6mm nozzle, 0.3mm layer, 3 walls, 15% infill
7.1 h
2 plates

Boost
67
117
75
6
394
389
Released

Description

Can be printed in PLA or PETG without any supports.

3 wall recommended.

In the right corner there is a hole for wires (if using external power supply).

Can be used with or without led light. Two places to install led:

  • on the angled lip (require cutting and soldering) this will let light flow to be directed down;
  • on the rounded part under the lip (without cutting or soldering);

 

Comment & Rating (75)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 15% infill
printed in white PETG. had to use a hammer to get the joints to go together, very tight fit, but good solid result.
The designer has replied
1
Reply
That's shrinkage of the plastic. With proper settings (compensation) hammer is not required :)
0
Reply
Vielen Dank, tolle Arbeit!
1
Reply
was hängt denn da an der tür? 🤔
0
Reply
Boosted
P1S Just wonderful! Printed with suggested settings (0.2/15%/3walls) with Bambu Orange PLA = Super Smooth , Super fit! NOTE: the seam in the front middle is Not Visible with the eye - the camera picked up on for some reason.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
buen trabajo. lo he impreso en una sola placa, todo perfecto, muchas gracias.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Kein reiben mehr des PTFE Schlauches an der Glasplatte, super Desingn und leicht zu drucken. Danke, hat mir sehr geholfen.
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
great fit. i added some 3M heat resistant tape to the inside and attached a light strip with no soldering needed. Wish there was a glass lift that was made for this too, would be a good accessory.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
work as intended. thx
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Fits very good
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Excellent! The ptfe tube no longer touches the glass.
0
Reply
schlichtes unauffälliges design, gefällt mir sehr gut 👍👍👍
0
Reply