Y splitter for AMS Bambulab by 3D pr.nt

3D pr.nt

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.12mm layer, 3 walls, 15% infill

Designer

31 min

1 plate

4.7(22)

0.12mm layer, 2 walls, 15% infill

40 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

257

210

Released

Description

Y splitter for AMS and external spool. Works with 6mm pneumatic connectors.

y splitter

ams

pneumatic connector

Comment & Rating (26)

@chrisledwards

Print Profile

0.12mm layer, 3 walls, 15% infill

Only issue is I didn't have to design it. Kudos to the designer.

@JB603

Print Profile

0.12mm layer, 2 walls, 15% infill

works perfect.

@JB603

Simple and functional, thank you. I did not find many slpliters for M6 thread.

@Titidag

Print Profile

0.12mm layer, 3 walls, 15% infill

0,12 mm Schicht, 3 Wände, 15% Füllung

@Xzaninou

Print Profile

0.12mm layer, 3 walls, 15% infill

It printed well but there was a bit of filament falling in the bottom hole. I cleaned it with a snip. The threading is perfect and the PC4s screw inside neatly. Though, when I ran a filament through it manually, it often got stuck and I had to wiggle to make it go on the other side. I don't feel confident that it will be ok to have this with the AMS and that it will work when changing filament.

@Raijinphoenix

Print Profile

0.12mm layer, 3 walls, 15% infill

@sbouquet92

question: which model of pneumatic connector ? (Most common M6 seems to be too big, probably M4 ?)

@Xzaninou

I have used PC4-M6 in my print but, as stated in my rating, I don't think I'll use this splitter. I don't know if the choice of using M6 is related to my issue or not.

@donduck73

Print Profile

0.12mm layer, 3 walls, 15% infill

worked good

@printmaject1969

Print Profile

0.12mm layer, 3 walls, 15% infill

Printed just fine, BUT, the part needs some work. After using a countersink bit to chamfer the center hole, it does work better? The file should have a 45-60 deg. chamfer from the bottom of the threads down towards the center filament hole! Then it would work WAY better, because I could ONLY chamfer so much with a Bit before exposing the "infill" !! I would Definitely reprint AND use if the file was repaired!