Tato varianta je určená pro ty z Vás kteří mají zásobu koleček z pojezdu os, ať z důvodu upgrade na lineární vedení nebo jen výměny z důvodu opotřebení. Záměrně jsem přidal i rameno protože když bylo už málo na špulce tak měla tendenci vypadávat což je asi častý problém u tohoto typu podavače.
Materiál:
4x šroub (M4) délka 34mm,šířka 5mm,průměr hlavičky 8mm
4x matka M4
8 koleček z lineárních pojezdů
4x šroub (M3) délka závitu 12mm (na přidělání konstrukce proti vypadávání špulky z podavače)
This variant is intended for those of you who have a stock of wheels from the axle drive, either due to an upgrade to a linear guide or just a replacement due to wear. I intentionally added a shoulder because when there was not enough on the spool, it tended to fall out, which is probably a common problem with this type of feeder. Material: 4x screw (M4) length 34mm, width 5mm, head diameter 8mm 4x mother M4 8 wheels from linear drives 4x screw (M3), thread length 12mm (to add to the structure against the bobbin falling out of the feeder)