What better for a wall decoration than a couple in love…even more if this love is still holding after two centuries.
The colours are a bit rough on this one on purpose, wanted to give a more dark tone.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
- PLA Overture Black
- PLA PolyTerra Charcoal Black
- PLA Overture Cement Gray
- PLA+ Sunlu Gray
- PLA Overture Light Gray
- PLA+ Esun Bone White
- PLA PolyTerra Cotton White
- PLA Overture White
Swap Instructions:
- Start with Black
- At layer #4 (0.4mm) swap to Charcoal Black
- At layer #12 (1.04mm) swap to Cement Gray
- At layer #14 (1.2mm) swap to Gray
- At layer #16 (1.36mm) swap to Light Gray
- At layer #21 (1.76mm) swap to Bone White
- At layer #22 (1.84mm) swap to Cotton White
- At layer #27 (2.24mm) swap to White for the rest.