trash bin voronoi by Greg Verin

Greg Verin

Household>Other House Models

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

8.7 h

2 plates

4.6(9)

Open in Bambu Studio

Boost

116

Released

Description

I wanted to have unique trash bin and learn how to design voronoi in fusion360.

This is a torture test for overhangs, printed in PETG as two separate pieces to slide in and lock by friction of layers.

I did not use supports, but there are few challenging bridges worth to consider adding them.

Edit - As there were questions regarding supports, I tried to reprint once more, this time with the hybrid tree supports (from bed only), much easier to clean, but the ratio of material for supports is ~60% of overall weight. Nevertheless - for science :)

voronoi

trash bin

Comment & Rating (13)

@spartanjjc

Print Profile

0.2mm layer, 2 walls, 15% infill

The designer has replied

@GregVerin

nice set of colors - mate green on glossy white :) what are the materials?

@spartanjjc

Replying to @GregVerin :

PLA Basic Gradient Ocean to Meadow and white PLA Support. Would recommend doing PLA Basic white as the support filament is very brittle.

@MakeNBake

Print Profile

0.2mm layer, 2 walls, 15% infill

Certain angle make it hard to maintain smooth bridging but I did not use any supports. If you do use supports I'm sure it would print better.

(Edited)

@sh1ver

no support?

The designer has replied

@GregVerin

I printed without - means some cleaning is required afterwards (that's why I called it a test for bridges/overhangs). I did not try to print it with the supports, but checked how the slicer looks like with tree support from the bed - looks good enough to test.