Fish Tank Planter
Copyright Claim
Fish Tank Planter
Boost
3
9
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.9 h
1 plate
Boost
3
9
3
0
10
3
Released
Description
Little fish tank planter I made to fit on the side of my tank. Clip perfect for sides up to 10.6mm thick.
Printed in PETG, I recommend using tools to loosen the support around the clip if it comes out a bit snug
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue:model separated when trying to remove from plate
Other Issues:layer separation.
The designer has replied
0
Reply
Thanks for your feedback, did you print in PETG?
I printed multiple times with no issues in that, but did not test on other materials.
0
Reply
It was PETG, but I think it was more a issue with the filament more than the model. Will try again with different filament and and layer height. Don't think it is a issue with your design.
(Edited)1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld