mountable phone holder
Boost
34
44
10
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
30 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
53 min
1 plate
Open in Bambu Studio
Boost
34
44
10
2
76
67
Released
Description
printed with an ender 3 to display antique plates, usable for anything, easy to disassemble, very resistant if printed with 15% infill, not bulky to carry with you
Comment & Rating (10)
All
I made this stand for our Dungeon master and also this picture. Thank you for the design of the stand. It was also a very easy print.
The designer has replied
1
Reply
Thank you so much for the nice comment, I'm glad to hear that it's so useful, especially when used by a dungeon master. A thousand thanks
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Works nice
The designer has replied
1
Reply
thank you very much
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Prints well and looks nice too!
The designer has replied
1
Reply
thank you,I hope it is useful to you
(Edited)2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect print came out just as i wanted
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Holds plates, phones and so much more!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I thought the pieces would fit a little tighter, but it still works as expected.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld