Low profile led frame for Bambu X1 and others. by kjbturok

kjbturok

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.24mm layer, 2 walls, 15% infill

1.6 h

1 plate

5.0(4)

Boost

Released

Description

*****Important ****

-To print on Bambu Lab X1, deactivate the flow calibration in the slicing program.

-Print on PETG, ABS or ASA.

*****************************

A frame for LED strip of no more than 11mm wide for the Bambu X1 printer. It could be used in other printers.

It is not very different from the existing ones. Only it is narrow and has corners and ribs to hold the LED strip. My LED strip peels off and is thus prevented.

It can be glued on the AMS, on the upper glass and glued under it.

To place it under the AMS it is necessary to place an extension for your feet. I recommend the following.

https://www.printables.com/es/model/266659-bambu-lab-ams-riser-feet-16mm

If you find that the led strips come off, I have attached some corners and ribs that you can glue and that will keep the led strip in place.

If you like my designs give me like and share. If you like them a lot invite me to a coffee.

https://www.buymeacoffee.com/kjbturok

https://www.paypal.com/paypalme/ChinadlaConchinchina

Thanks!

ESPAÑOL

*** Importante ***

- Para imprimir en Bambu Lab X1 desactiva la calibración de flujo en el programa de rebanado.

- Imprimir en PETG, ABS o ASA.

*****************************

Un marco para tira led de no más de 11mm de ancho destinado a la impresora Bambu X1. Se podría usar en otras impresoras.

No es muy distinto de los que ya hay. Solo que es estrecho y lleva esquineras y costillas para sujetar la tira led. Mi tira led se despega y asi se evita.

Se puede colocar pegado en el AMS, sobre el cristal superior y pegado debajo de este.
Para colocarlo debajo del AMS es necesario colocar una extensión para sus pies. Te recomiendo el siguiente.

https://www.printables.com/es/model/266659-bambu-lab-ams-riser-feet-16mm

Si te ocurre que las tiras led se te despegan, he adjuntado unas esquinas y costillas que puedes pegar y que mantendrán la tira led en su sitio.

Si te gusta mis diseños dale me gusta y comparte. Si te gustan mucho invítame a un café.

https://www.buymeacoffee.com/kjbturok

https://www.paypal.com/paypalme/ChinadlaConchinchina

Gracias!

Comment & Rating (4)

@GenericUser

Print Profile

0.24mm layer, 2 walls, 15% infill

Printed in PETG, cut up led strips and wired the corners to flatten the profile.

@Thully

Print Profile

0.24mm layer, 2 walls, 15% infill

Print profile worked well on the X1C with PEI plate. I used black Bambu PLA Basic. The model itself is good, but would be better if the underside was a diffuser.

(Edited)