To replace the original fan of the Bambu X1 motherboard without disassembling the original one.

This is a bracket for a 4410 fan (in my case I used a noctua NF-A4x10 5V PWM) to install on the Bambu X1 3d printer without disassembling the waste ramp, heatsink and the original fan.

The fan is glued to the side of the machine using double sided tape in front of the heatsink.

Since the power connector of the noctua is not compatible with the original fan connector, it is necessary to cut both and join.

Since the color coding on the wires that Bambu uses on his machine is a bit different than the rest, I used trial and error until I succeeded. I have doubts if the fan is actually running self-regulating, so if anyone thinks the connection I used is wrong, please leave it in comments. Thank you.

Disclaimer:

This setup requires a minimum of hablity. You may end up with a damaged fan or worse, the printer board or yourself damaged.

Do it at your own risk.

For this project you will need the following:

-Print media. PETG, ASA, etc. is recommended. I do not recommend using PLA.

-A 4410 PWM 5V fan.

https://www.amazon.es/gp/product/B07DXS86G7/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

-A pair of fan screws.

-Quality double-sided tape.

If you like my designs give me like and share. If you like them a lot invite me to a coffee.

https://www.buymeacoffee.com/kjbturok

https://www.paypal.com/paypalme/ChinadlaConchinchina