Print in Place Wrapping paper holder Ikea Billy
Copyright Claim
Print in Place Wrapping paper holder Ikea Billy
Boost
6
9
4
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
6
9
4
0
8
10
Released
Description
You don‘t need any support structure, it is complete print in place. Maybe you need a little bit force for loosing the parts.
For mounting i used double tape.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Hard to loosen
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
tolerances too small, broke off when taking apart
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
doesnt fit
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Other Issues:My only issue with it was after printing it was practically impossible to get the piece separated so that I could use it.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld