As my room was becoming a mess because of my Bambu Mini “poops”, i needed to find a solution. So i've designed this “diaper” that will prevent poops invade your floor or desk. This solution is not suited for AMS - multicolor configurations, as they generate much more waste during color changes. In my case, purge is done just during flow calibration (or when i change spool), and my solution is fine.

I've designed three different sizes (in the picture you can see the smaller one), with different bin volumes.

I hope you enjoy it and i'm open to suggestions and comments.

Printed with pla and 0.2 layer height (no supports needed..there will be some bridging on the top surface, but few centimeters are fine for most of the printers).