A1 Triple LED bar. Remixed by kimbermobile

Remixed by

kimbermobile

3D Printer>3D Printer Accessories

Print Profile(1)

All

0.2mm layer, 2 walls, 25% infill

Designer

1.3 h

1 plate

4.5(2)

Open in Bambu Studio

Boost

Released

Description

Made a rear mount light bar that clips onto the printer and hangs 3 LED light bars. I will post the link to the LEDS

https://a.co/d/2YkPOIC

Comment & Rating (7)

@papayeiser

I really like this print. I picked up the set of lights you referenced, and they fit just a touch hard. I used the grooves in the light frame, to keep them away from the rest of the print in case of any heat build-up. They work great! My print area is now lit up in a good way. Thanks for the model!!!

@SLCPANTHERS

https://www.amazon.com/dp/B0BHWQ6NH1?_encoding=UTF8&;ref_=cm_sw_r_cp_ud_dp_SZ74VCMPEB70GVG1DB7D&th=1IS THIS THE CORRECT LIGHT KIT? HOW DOES THEY BRACKET ATTACH TO THE BAR ON THE A1 PRINTER? LOOKS LIKE A TIE RAP BUT IT DOES NOT GO AROUND BRACKET? THAT IS WHAT PULLS UP WHEN I GO TO THE LINK PROVIDED.

@jeffschacher

Boosted

Just what i was needing ! Thanks

@wsantos

Print Profile

0.2mm layer, 2 walls, 25% infill

Really hard to fit the lights, but works

@SLCPANTHERS

https://www.amazon.com/dp/B0BHWQ6NH1?_encoding=UTF8&;ref_=cm_sw_r_cp_ud_dp_SZ74VCMPEB70GVG1DB7D&th=1 IS THIS THE CORRECT LIGHT KIT? HOW DOES THEY BRACKET ATTACH TO THE BAR ON THE A1 PRINTER? LOOKS LIKE A TIE RAP BUT IT DOES NOT GO AROUND BRACKET?