This design is based on a design shared by Sam Schmidt from the Voron Facebook group and on the remix of this project created by "MrTeliP" from printables.

I modified the design a lot so that the hotend was mounted very solidly and could not swing from side to side.
The hotend fits into its place quite tightly, and is additionally attached with an M3x16 screw (there is room for two, but one is enough) and two 2x11mm self-tapping screws screwed into the aluminum radiator. The M3 screw is screwed directly into the plastic, be careful not to overtighten it.

Updates 10/10/2023:
-Now compatible with TAP.
-SB_Bambu_Front has been modified so that the hotend fan does not blow on the heatblock and heatbreak.

Fits the Bambu hotend clone from Aliexpress.