U can easily replace red with orange if u prefer. i went for red just to have it more deep.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Matte Scarlet Red Transmission Distance: 10
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 4
Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Scarlet Red
At layer #13 (1.04mm) swap to Yellow
At layer #14 (1.2mm) swap to Jade White for the rest.