Filament Rack by JonnayLin

JonnayLin

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

2.2 h

1 plate

5.0(9)

2 shelf parts only 0.2mm layer, 2 walls, 15% infill

3.1 h

1 plate

5.0(1)

Boost

135

Released

Description

I designed this to fit a 1 in dowel pretty snugly. I used drywall anchors that had included #8 screws and used #8 washers that were less than ½ in in diameter just for added security.

Comment & Rating (16)

@Magnus_

Very nice, thanks

(Edited)

@MZ3d

Boosted

davvero davvero bello questo progetto , semplice ma efficace. stampato su Artillery x1 , perché possiedo una A1 mini . adesso ne sto costruendo un'altra fila per i filamenti rimasti fuori :)

@Stevens3DPrints

Print Profile

0.2mm layer, 2 walls, 15% infill

it’s working great for holding my filament. I might add another one in the center for more support later on.

(Edited)

@MrSquigglex

Print Profile

0.2mm layer, 2 walls, 15% infill

can we please get it with just the hook and not the end thing please. Only effected on mobile, thanks for file. Was able to delete on computer

(Edited)

@Magnus_

you can also start the print and then go to the printing page and skip the unwanted part

@Mikerfink

Used PVC instead of wooden dowels, and had placed a few spools on while I was grabbing a bracket to go for the middle area and the whole thing snapped, was only over a 40" span. Just make sure you have all of your parts up 1st. Not sure if printing at 100% infill would be better also.

@jjesseday

Why would you place spools on it before all the brackets were up? Probably why it broke.

@MZ3d

Boosted

IL TOP

@hayes.darrick

Print Profile

0.2mm layer, 2 walls, 15% infill

works beautifully. Thank you

@Magnus_

Print Profile

0.2mm layer, 2 walls, 15% infill

Nice and easy but maybe it could do without the brim to reduce post processing

@purebloodwashed

Print Profile

0.2mm layer, 2 walls, 15% infill

mounted well and holds 10kg in spools pretty easy. I noticed I had to use #6 screws instead of #8. the counter bored holes were a little too narrow for a #8 screw, but even so, the shelf holds nicely.