Elephant Battery Dispenser
Copyright Claim
Elephant Battery Dispenser
Boost
21
31
7
Print Profile(2)
Elephant AA battery dispenser - 0.4mm nozzle, 0.2mm layer, 2 walls, 12% infill, NO brim
Designer
1.6 h
1 plate
elephant AAA battery dispenser, 0.4nozzle, 0.2mm layer, 2 walls, 12% infill, NO brim
Designer
1.3 h
1 plate
Boost
21
31
7
1
39
30
Released
Description
Easy to print two pieces battery dispenser.
Just apply some super glue on the marks and hold the pieces together while it dries, and its Done!
The pieces are flat from the bottom, but be sure to keep the piece upright while gluing to avoid any movement left when finished
Recommended settings:
-orientation: same as default, the flat side towards the buildplate
-material: pla, petg
-layer height: 0.2
-supports: NO
this is one member of my original "HomePals" collection that you can see here:
Comment & Rating (7)
All
Boosted
To save some time, I printed it on my A1 with the 0.6 nozzle (0.30 mm standard). It worked like a charm. I left the other settings as they were. BambuLab PLA Matte Grey.
0
Reply
I’m excited to print it. It looks very good.
0
Reply
Print Profile
elephant AAA battery dispenser, 0.4nozzle, 0.2mm layer, 2 walls, 12% infill, NO brim
Printed with Transparent Red PLA
0
Reply
Great Print. Love it.
0
Reply
Print Profile
Elephant AA battery dispenser - 0.4mm nozzle, 0.2mm layer, 2 walls, 12% infill, NO brim
0
Reply
Print Profile
Elephant AA battery dispenser - 0.4mm nozzle, 0.2mm layer, 2 walls, 12% infill, NO brim
0
Reply
Print Profile
elephant AAA battery dispenser, 0.4nozzle, 0.2mm layer, 2 walls, 12% infill, NO brim
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld