Bambu Parts Box by Eminent3D

Eminent3D

Tools>Organizers

Print Profile(5)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

9.3 h

1 plate

4.6(44)

0.2mm layer, 3 walls, 15% infill

Designer

1.8 h

1 plate

4.7(18)

Box + Lid, 0.24mm, 2 Walls, 10% Infill

6.7 h

2 plates

4.6(9)

0.2mm layer, 2 walls, 15% infill

8.3 h

2 plates

5.0(1)

Click to see more

Open in Bambu Studio

Boost

395

729

967

511

Released

Description

Holds 8 nozzles, 4 of which can be complete hot ends with fans. Prints in place and barely fits at 250mm wide. Print settings i used below. Printed in PETG in photo. The magnets below are required as they act as the latch to keep the box closed and also keep the inside cover on ti keep the items in the lid from spilling.

.20 layer height

5 top and bottom layers

3 wall loops

20% infill

Magnets needed

(4) 8mm x 4mm or (8) 8mm x 4mm

(16) 4mm x 2mm

Comment & Rating (84)

@bjondal

Printed in PETG-CF fits perfekt !

@seanspring816

Print Profile

0.2mm layer, 3 walls, 15% infill

Great print quality well worth it good design.

@rajrentfro

Print Profile

0.2mm layer, 3 walls, 15% infill

I had a first layer defect but it wasn’t the fault of the design. the tolerances of the stl are spot on. not much play in any of the sockets for hot ends. impressive. even with the wonky corner that didn’t print right I think I’m going to keep this and use it. Good job.

The designer has replied

@Eminent3D

Nice looking print my guy!

@FP3D

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

this came out great! I would recommend (if you make a 2.0) to add a lip around the edge so the two halves always close shut aligned. Other than that, this is an awesome container. I'm thinking about adding a (this side up) sticker to the top of the box.

@Filmman586

Print Profile

0.2mm layer, 3 walls, 15% infill

great print, printed the box just needed the lid.

@gbomacfly

Print Profile

0.2mm layer, 3 walls, 15% infill

Prints very well!

@AKWA2288

Pretty cool print. Printed it in PETG and slow. The hinge works and all however see the photos regarding the print quality when it came to the hinges.

@Fabian_

Print Profile

0.2mm layer, 3 walls, 15% infill

Printed in PLA, waiting on the magnets. Profile uses quite a lot of filament, can probably be reduced

@tekki86

Print Profile

Box + Lid, 0.24mm, 2 Walls, 10% Infill

(Edited)

@jwbaker360

Print Profile

0.2mm layer, 3 walls, 15% infill

couldn't get it to close without breaking

The designer has replied

@Eminent3D

interesting. sounds like something is off with the printer quality. i would do maintenance like belt tensions and lcean and lube all rods and z screws

(Edited)