great print and very tough box, but it‘s a bit difficult to open and close as the retaining clip does not have a lot of flex. with a bit of sanding it‘s perfect.
I printed this in PLA, its a great box but would be even better with snap lock hinge. The hinge is really tight, should I have printed it in another material?
hello, I printed out the V2 AA case on a x1c carbon and came out lovely, but the hinge is super tight and difficult to open and close. it was printed in PLA but should I use a different material, this box would be prefect with a flip hinge
Other Issues:when attaching lid to box, hinge will break. only way to attach is pushing with a lot of force due to design. Will try again if hinge gets an overhaul. Love the design though!
I used pla+ if that matters. the hinge did not want to go at all. not sure why. I did 2 of these and they both ended the same way. the box itself is awesome and rugged especially if you use gyroid infill ($2.51/2 boxes!) but the hinge is a b***h to connect.