Giantarm AMS spool adaptor by io_gus

io_gus

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 10% infill

Designer

28 min

1 plate

4.7(10)

Open in Bambu Studio

Boost

Released

Description

Hi!

I created this adapter for GIANTARM spools to use them inside the AMS, avoiding problems when rewinding or loading the filament. Without this adapter I noticed that the spool was skipping during the charging phase. Two adapters must be printed to fit together on both sides of the coil. They are reusable and can be used on all 197mm diameter reels.

spool

adattatore

adattatore per bobina

Comment & Rating (12)

@spinels.spongy_

Thanks for the model. My GiantArm new spool is measuring in at 195mm so this spool adaptor is too large. Reducing X and Y to 99.5% scale seems to work. Question. Why did you not create a wider right side adapter to help guide the spool feed like other adapters??

(Edited)

@RHSJR0727

Print Profile

0.2mm layer, 2 walls, 10% infill

I had to shrink to 99.5% on the X & Y to work with my ABS Spool FYI

@3D_Printing_Guy

Print Profile

0.2mm layer, 2 walls, 10% infill

worked great, thanks

@S3JO

Good, thanks!

@user_3670630760

Print Profile

0.2mm layer, 2 walls, 10% infill

@has5usmc

Print Profile

0.2mm layer, 2 walls, 10% infill

@goldenkaeru

Print Profile

0.2mm layer, 2 walls, 10% infill

@TheGunPsy

Print Profile

0.2mm layer, 2 walls, 10% infill

Other Issues:the part did not fit the spool. It just falls right off. I will have to adjust the profile and scale the model to make it work. if allowed, I will upload the print profile. Thanks and nice modeling work btw, this is a good adaptation that flows nice with the aesthetics of the spool.