Filament Rack
Remixed by
Copyright Claim
Filament Rack
Remixed by
Boost
11
22
6
Print Profile(1)
0.25mm layer, 3 walls, 15% infill
Designer
5.9 h
2 plates
Open in Bambu Studio
Boost
11
22
6
1
29
56
Released
Description
i made this remix as the original didnt fit my needs
orginal design is from Nacho1741
i remixed it to have holes to put screws in the rack and the risers are 3cm longer, so i could put rolls in easy
i havnt changed the hole diameter so its still: ½" SCH 40 PVC
i used broomsticks instead and grinded them to the correct size for fitting.
Comment & Rating (6)
All
Print Profile
0.25mm layer, 3 walls, 15% infill
this is the best filament storage setup I've seen
1
Reply
Print Profile
0.25mm layer, 3 walls, 15% infill
I’ve been looking for a nice modular rack for a while, and I’m so happy I found this one. It took me quite a while to get the tolerances dialed in, but once I did it started coming together! I printed the sides in Elegoo Rapid PLA+ (black), then used 1/2” pvc and spray painted it for the bars. works great with 10 rolls per shelf (26”) and 4 tiers high!
1
Reply
if I didn’t want to use the screw holes but I did want to use the longer vertical bars, would they be compatible with the other model’s horizontal bars? Also, what is the width of the side frames? thank you :)
The designer has replied
1
Reply
the only diffrence are the holes so u can use the original ones without the holes.
(Edited)
0
Reply
Print Profile
0.25mm layer, 3 walls, 15% infill
Made the original first, but these 3cm made a world of difference. Spools no longer touch the pipe above when taken the spools in and out.
1
Reply
Print Profile
0.25mm layer, 3 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld