Darth Vader in flames

Wow! I found this picture by accident but couldn't walk away either! Did a go in hueforge and volia… The best thing is you don't have to use any fancy filament colors, just use basic black, red, orange and yellow! I think the result is outstanding.

Remember if you sant to scale, do it only with x and y axis, z must be the same as original.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Orange Transmission Distance: 10

Swap Instructions:
Start with Black
At layer #5 (0.48mm) swap to Red
At layer #11 (0.96mm) swap to Yellow
At layer #17 (1.44mm) swap to Orange for the rest.