This is a themed flat lid that is designed to fit my “Golf Ball Trash Can”.

This would make a great gift for that golfer in your life. A perfect place to store those extra balls!

Assembly instructions:

1. Print everything (both plates)
2. Remove brims from the small connector pins and also the handle.
3. Use a small screwdriver to remove the support from each ball divet. They should pop out without too much effort. Think of it as mindfulness.
4. Place the handle on the lid and then position the bracket to line up with the holes.
5. Press each pin into place firmly until it is fully seated. Once in there, it is not coming out again!