First successful HueForge print I have designed, Fry from Futurama “Not sure if…” meme. 5 colors but can be printed easily with only 1 AMS! If you have any suggestions for improvement, I would love to hear them.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm
1 Wall, 9 layers top shell and 999 bottom shell.

Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Sunlu Red Transmission Distance: 6
PLA+ Sunlu Orange Transmission Distance: 5
PLA+ Sunlu Skin Transmission Distance: 5
PLA+ Sunlu White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #3 (0.32mm) swap to Red
At layer #20 (1mm) swap to Orange
At layer #31 (1.44mm) swap to Skin
At layer #37 (1.68mm) swap to White for the rest.

To use 5 filaments with 1 AMS:

Load up your AMS with Black, Red, Orange, and Skin filament, having White on standby.

Select the AMS slot containing black for the white.
When Black layers are done printing, switch out the Black filament for White.