Lid riser for the P1S with integrated collapsible vents.

Required Material without vents at the back:

• Printed parts:
  • Blind A x3;
  • Blind B x3;
  • Front Right x1;
  • Front Left x1;
  • Back Right x1;
  • Back Left x1;
  • Knob x6;
  • Tongue x4.
• Hardware:
  • M3x12 Buttonhead screws x6:
    • For the knobs;
  • M3x12 flathead screws x16;
    • For the tongues;
  • M3 nut x22.

At first, I did not put vents at the back. They would have been a pain to reach in order to open and close the vents on my setup. If you want vents at the back, you will need these additional parts:

• Printed parts:
  • Back Right with vents (replaces Back Right);
  • Back Left with vents (replaces Back Left);
  • Knob x2 ( 8 total);
  • Blind A x1 (4 total);
  • Blind B x1 (4 total);
• Hardware:
  • M3x12 Buttonhead screws x2 (8 total);
  • M3 nut x2 (24 total).