Perfect. with glowy pla presents

supports came of pretty easy, the stem could have been supported a bit better or printed slower. overall nice design

sehr langer druck. sehr viel Abfall. aaaaber.... sehr sehr hübsch :))))

with pla silk

se me ha mezclado algo de negro en la parte roja y no se como evitarlo, alguna idea?

I uploaded a remix where I removed about 1mm from the bottom which allows it to print without supports but the creator of this one copy claimed it and had it taken down. 🙄 If you want a better print cut a bit off the bottom to make it flat, set the layer height to .12 and disable supports. It comes out a lot better. Takes a little over 5h to print in color though.

neat little print.

The bottom of the mushroom is rough and uneven

printed pretty good would like to see the bottoms made a little wider to have more flat surface area on the build plate and less supports

change the height layer to 0.12, use tree supports, and add an outer brim to get an almost perfect print. still need an exacto knife to clean up the bottom a little