This is a Lightbox with the head from Terminator T-800.

Attention !!

The Lightbox was printed with 0.4 nozzle and could be gaps on several tight spots if you not dial your printer correct …
Make sure you dial your printer right (more initial layer flow or more flow ratio .. or both) or for better and safer results use a 0.2mm nozzle.


there is a hole on the back side to hang the Lightbox and a hole on the side for a USB-C adaptor …
If you don't want to use the USB adaptor i have also included a small cap with a 4mm hole just to fit your cable in and another cap without a hole if you want to use a battery pack in it.

Enjoy !

USB-C Adaptor :https://s.click.aliexpress.com/e/_DBngla9
LEDs : https://s.click.aliexpress.com/e/_DnlApXf