Gearbox A1 Faceplate by DarkSword Creations

DarkSword Creations

3D Printer>3D Printer Parts

GIF

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 100% infill

Designer

5.2 h

8 plates

3.6(10)

Open in Bambu Studio

Boost

110

108

Released

Description

Hello! im totally addicted to A1 Faceplates, so i have created a new crazy cover!

The fully mechanical “Gearbox A1 Faceplate”

i hope you like it!

update 1.6

i have received some feedbacks about the main gear part, so i have added some new plates so you can print only the main gear at varous scales

plate 5: only main gear (100% scale like the 01 and 03 plate)

plate 6: only main gear (98% scale)

plate 7: only main gear (96% scale)

plate 8: a main gear set (scale 100%-98%-96%-95%-94%)

be careful and dont be rude when you remove the original cover and put the new one

mount istructions:

remove the original cover → remove original cursor → add new cover → add new cursor , add gears, clip with pins (must be tight)

if the standard pins are too loose, print the plate no°2, it contains different scale pins, use the one that fits better

Gears printed in Silk, Cover in Pla

This is a Beta, let me know if everything works

Dislaimer: im not responsible for any damage to the printer, this is a complex cover, so everything must be printed good and well assembled, i have tested some prints at ludicrous speed and everything works fine, the pins must be fit tight!

Comment & Rating (15)

@Fabcreations

Boosted

Print Profile

0.2mm layer, 2 walls, 100% infill

Amazing detail only complaint is the main gear that attaches to the extruder gear is too big had to scale it down by 5% in order for it to fit correctly, otherwise it just spins around the extruder gear

The designer has replied

@DSCreations

thank you for your feedback, i have tried several sizes of scale and uploaded the most compatible for me. but my filament have a proper flow and expansion so it fits perfectly on my printer, i have tried to downscale to various % but i need too much force to put the gear on. based of this and another feedback i have uploaded an update. thank you again for your help!

(Edited)

@Matthew.starke1

mine won’t turn disappointing print. tried to post a video here but it won’t let me. the gear that goes on the shaft is a bit to big for the shaft.

(Edited)

The designer has replied

@DSCreations

hello, im sorry to hear that, this may be happen because the flow and settings of your filament are different from mine. i can try to add a only gear profile, meanwhile you can open in bambustudio the model and scale and print only the main gear until you find the correct size. (not too much)

@JustinVellier

Print Profile

0.2mm layer, 2 walls, 100% infill

the drive gear wasn’t a snug enough fit, it just spun in place.

@Bentley.breakey

Print Profile

0.2mm layer, 2 walls, 100% infill

Printed well, many sizes to choose from. I didn't end up getting it to work and because of the recall I didn't try other sizes to make it work. I did red with gold gears and black buttons which was a cool color combo.

@Matthew.starke1

Print Profile

0.2mm layer, 2 walls, 100% infill

Other Issues:printed this and I couldn’t get the gears to turn I used default settings.

The designer has replied

@DSCreations

hello, this has been printed many times with this profile. i suppose the problem is the flow of your filament