Summary

This is a clamp designed for table use. you can use it to stick something, or to hold your smartphone to take some pictures, videos, or other purposes.

You can only print part1-3, for single-use without the base.

All parts are designed especially for 3D printers, so you can try to print it without support, but I recommend printing it with support for good assembly quality.

The infill should be larger than 60% for the requirement of solid.

Be careful when fixing your smartphone on it, don't screw it too tight, in case the screen will break. You can try to put some soft material like rubber between the screen and the fixture.

If you find any new use of it, please post it and share to us, hope you can enjoy it:)

Print Settings

Printer Brand:

Anycubic

                                            Printer:                      
All-metal Mega

Rafts:

                                            Supports:                      
Doesn't Matter

Resolution:

200

                                            Infill:                      
60-80

Filament:

any PLA /ABS/PETG

any

Custom Section

            You can only print part1-3, for single-use without the base.
                
            The largest lean angle is 42.5 degree
                
            very firm when holding smartphone inclined