Hueforge Stand
Copyright Claim
Hueforge Stand
Boost
18
28
9
GIF
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
18
28
9
0
58
12
Released
Description
Perfect stand for your "hueforge" prints
Great stability and customizable colors, to adapt it to your print.
Very little material is used, printing supports are recommended.
in my file, I put 2 models because I needed 2, but you are free to delete one or print even 4 at the same time.
Comment & Rating (9)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Good model, came out really well. I had small issue with stringing on the top of right corner , buy I believe it's me, not print profile.
The designer has replied
1
Reply
A thousand thanks.
out of curiosity, could you show me the defect you mention once the printing is finished?
You can't tell from these photos.
0
Reply
here you are. right top corner. its stringing ,but I reset printer to factory settings, then I believe that I lost whole printing profile. I'll need to set up retention etc. Thanks
0
Reply
what size does it fit?
The designer has replied
0
Reply
Hi, the size of the stand is 150x58x142 as in the attached photo.
The size of the hueforge that I printed is: 185x210
But you can also print a little bigger
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The designer has replied
0
Reply
Thank you
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld