As you are the only one having problems with the print profile check the following (helps with all prints :) Make sure to have the correct and dry filament according to the print profile. Dry it before use if in doubt. https://wiki.bambulab.com/en/filament-acc/filament/dry-filament Make sure to have the correct build plate according to the print profile installed, cleaned and prepared. DO NOT TOUCH THE PRINTING SURFACE. https://wiki.bambulab.com/en/filament-acc/acc/plates Make sure you have tuned the filament.https://wiki.bambulab.com/en/x1/manual/manual-flow-rate-tuning Make sure to have your print bed trammed and leveled. https://wiki.bambulab.com/en/x1/manual/manual-bed-leveling Sometimes just lowering the "Max Volumetric Speed" in the filament settings helps with not perfectly tuned in printer/filament.