BambuLab Wide Poop Chute w/ Magnet Holes Remixed by thetonestarr

Remixed by

thetonestarr

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.28mm layer, 2 walls, 15% infill

Designer

4.9 h

1 plate

4.8(20)

Open in Bambu Studio

Boost

119

126

Released

Description

Remix of the BL Poop Chute with Magnets from Ga Design; I was consistently running into problems with it clogging before the waste would get to the bottom of the bin.

This version has a 75% wider chute, allowing for the chunkiest of poops to properly flush out.

Use 6mm wide x 2mm thick magnets. I used these https://www.amazon.com/dp/B07XRQ44VC

Comment & Rating (24)

@user_3714247037

Print Profile

0.28mm layer, 2 walls, 15% infill

Easy print that worked perfectly with the profile

(Edited)

@Stanzo89

for the magnets should I glue or stick another magnet on the inner side to hold it in?

The designer has replied

@thetonestarr

I would use glue. Putting another magnet on the inside gives your purge material something extra to get caught on.

@gazman321

Boosted

Excellent

@the_Andy

Boosted

Thanks for the larger mod!

@janschilling198

Print Profile

0.28mm layer, 2 walls, 15% infill

Great, thanks

@Talasarian

Print Profile

0.28mm layer, 2 walls, 15% infill

Works so much better than the slim version. Kept having clogging issues with the narrow version with the poop getting stuck at the entrance

@m6speed

Print Profile

0.28mm layer, 2 walls, 15% infill

best one i've printed, thank you!

@St4pl3r

Print Profile

0.28mm layer, 2 walls, 15% infill

The higher walls and wider opening are appreciated as other designs available have filament get stuck or overflow very quickly. Some odd layer adhesion issues higher up the walls