x10 Can dispenser (A1 MINI Version)
Remixed by
Copyright Claim
x10 Can dispenser (A1 MINI Version)
Remixed by
Boost
16
48
13
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
8.9 h
4 plates
Open in Bambu Studio
Boost
16
48
13
3
80
114
Released
Description
Fully ready to print on A1 mini, can hold up to x10 UK size pop cans. done it slightly smaller to fit the a1 mini bed. Works perfect.
Knock the speed up to sport on all parts to reduce print time.
This is based off the can dispenser on Thingiverse, full credit goes to original creartor - Can dispenser (12 cans, low filament) by CueBall909 - Thingiverse
Comment & Rating (13)
All
Printed fine on A1 Mini. Definitely recommend running it on sport mode to speed things up.
0
Reply
i printed it on ludicrous mode and it printed perfectly
0
Reply
I can't speak for all countries, but in many European countries the "sleek cans" are used. The size is 146 x 58 mm.
As there is no other can dispenser for the A1 mini, I printed this one and then created 4 extensions using very simple methods. It's not professional, unfortunately I'm a noob in 3d printing and all the software required.
It works perfectly, just doesn't look as good as without these extensions.
0
Reply
Are you supposed to glue the pieces together because it definitely does not stay together by just trying to snap things into place. Pretty disappointing considering how long it took to print.
The designer has replied
0
Reply
yes glue them together 😀👍
0
Reply
Replying to @dylcro2
Thanks for the response. Unfortunately it doesn't fit american size cans. Ended up being a fun, but costly project.
0
Reply
Boosted
As an avid Coke drinker, I love this modal. One of my first bigger prints on my A1 Mini and all went together perfectly.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld