I loved the filament cutter remix by Remii Latte, but I wanted to use Bambu blades, since I have a bunch laying around. Now I can! I made a few additional changes as well. The blade now sits at 45 degrees. I find it is easier to load filament into the AMS lite when the filament is cut at an angle. I also flipped the logo around so it faces you when cutting the filament. I have included two versions of the holder. One version has the Bambu logo colored. But you save a ton of filament by printing in one color, so I included another version with the letters removed so they are just embedded on the handle. This model uses two M3 25 screws. I was able to use extra screws that came with my A1. Use a small peice of filament cut flush to secure the cutter into the slot. It also needs two 25mm x 4mm springs. I was able to find springs that fit in old pens I had laying around. Feel free to comment with any suggestions or issues. Printed well using the standard Bambu .2 profile for the handle and the .2mm strength profile for the cutter assembly and blade holder.