Valentine Sweetheart Candy Danglies
Valentine Sweetheart Candy Danglies
Boost
89
139
11
Print Profile(1)
0.2mm nozzle, 0.1mm layer, 4 walls, 10% infill
Designer
4 h
1 plate
Boost
89
139
11
0
103
73
Released
Description
These three pieces dangly earrings are sure to be a season favorite!
*Must use a .2mm nozzle for lettering to work. Also, the hinge is a bit fragile due to being so small but should strong enough to hold up as earrings.
Comment & Rating (11)
All
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 10% infill
Not bad. A tad rough. printed on Minni with .2 nozzle
1
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 10% infill
letters didn’t work for me
The designer has replied
0
Reply
Did you use a .2mm nozzle?
0
Reply
Replying to @IbaviosaBaubles
yes sir
0
Reply
I can not get the writing to show on the top layer...any suggestions?
The designer has replied
0
Reply
Hmm, have not had that issue. Are you using the profile I uploaded? And a .2mm nozzle?
0
Reply
Super cute, can't wait for my current print to get done so I can print these!
1
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 10% infill
Other Issues:when I printed the bottom didn't show the text and they broke apart easy
The designer has replied
0
Reply
I'm sorry these did not print well for you. Did you use the provided profile and settings? Also, did you use a .2mm nozzle? Unfortunately, yes they are a bit fragile, but should hold without adding pressure.
0
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 10% infill
1
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld