I was using the supplied frame bracket for the Litelok X1 but it could only fit on the side of my Hauler rack and although it didn't get in the way it was very wobbly.

So I decided to design something that could safely mount the lock under the Hauler rack.

I created 2 versions of both brackets, one design allows you to embed the M5 nuts inside the print (thats what I did) which makes it easier to fit and remove without the nuts falling out. In your slicer just get the print to pause at the right height to insert the nuts. The second version allows you to insert the nuts when needed.

I recommend printing in something that can withstand the elements like ASA.

Required Hardware:

• 4x M5 20mm bolts (can support longer bolts up to 25mm and maybe 30mm with an extra washer)
• 4x M5 Nuts
• 4x M5 Washers

A small donation or even just a Like goes a long way, Thanks!