Print-in-Place CR2025 Battery Case Remixed by Krookr

Remixed by

Krookr

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

34 min

1 plate

5.0(8)

Open in Bambu Studio

Boost

Released

Description

Model

Print-in-place model to hold CR2025 Batteries.

Print instructions:

0.2 or less layer height. No supports needed.

The hinge for this box is print-in-place. I used a 0.2mm clearance which should be fine for most well-calibrated printers. The first time you move the hinge may require a bit of pressure. Repeatedly opening and closing the box will make the hinge movement smoother.

Same goes for the clasp, which may be a bit hard to open the first couple of times. Open and close it a few times, and it should be fine.

Disclaimer:

This is not my own design, but by fuchsr: https://www.printables.com/model/63026-print-in-place-customizable-cases-for-button-type-

Comment & Rating (9)

@Demacles81

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed beautifully. Thank you.

@hellojoe

Print Profile

0.2mm layer, 2 walls, 15% infill

Thanks, will make organising my drawer a bit easier.

@JonRaymond

I've printed several of the other CR2025 holders and this one is by far the best. The hinge and clasp work very well together. The only improvement would be to add slots on the lid incase you open the box the wrong way.